Table of Contents
Advertisement
Message
The formatting of the card is abnormal or corrupted.
Replace the card or format the card using the FORMAT menu.
MBR Error Init CARD
Formatting erases all data currently on the card.
No SD card is in the unit. Load a recordable SD card.
No Card
There is no track in recording standby (armed).
You tried to enter auto punch mode or pressed the RECORD button when no tracks were in recording
No Armed Track
standby. (See "Automatic punching in and out" on page 45.)
Put a track into recording standby before pressing RECORD or activating auto punch.
There is no undo history.
No Undo History
There are no actions to be undone. (See "Undoing an operation" on page 39.)
The recorder transport is not stopped.
When the recorder is not stopped, this message appears if you press a button, such as UNDO/REDO, that
Not Stopped
works only when the recorder is stopped.
The unit is recording.
This message appears when you try to operate a menu while the unit is recording.
Now Recording
Some other operations are also not allowed during recording.
OUT point must
You cannot set the OUT point before the IN point.
be set after
Set the OUT point after the IN point.
the IN point.
The inserted SD card is write-protected.
Protected Card
To record or edit, turn off the unit and unlock the write-protection on the SD card.
When trying to use the export function, no recordings were found on the current song's tracks.
No tracks have been recorded in the current song, or virtual tracks with recordings have not been
Recorded Track
assigned to physical tracks.
Not Found
Select a recorded song, assign the track you want to export to a physical track, and then export it. (See
"Virtual tracks" on page 47.)
Edits and changes made since the song was loaded will be cleared, and the song will be reset to status it
Revert to
had when loaded. Proceed only when you are sure you wish to discard all changes.
discard changes.
The same track has been specified.
This message appears when using the clone track function if the source track is also set as the
Same Track
destination track.
The song is protected.
You are trying to change (record, edit, etc.) a protected song. (See "Protecting songs" on page 31.)
Song Protected
Unprotect the song.
All the stereo tracks already have recordings.
This message appears if you try to import a stereo file when all the stereo tracks in the song already have
Stereo Track Full
recordings, even if some mono tracks are still open.
All the tracks already have recordings.
This message appears if you try to import a file when all tracks in the song already have recordings. (See
Track Full
"Importing tracks" on page 65.)
Track editing failed.
Trk Edit Fail
Save the song, turn the unit off and on again, and then try the track edit one more time.
The track is too short.
You are trying to record in mixdown mode, but the time between the IN and OUT points is too short. The
Trk Too Short
IN and OUT points must be at least 4 seconds apart. (See "Setting IN/OUT points" on page 44.)
Turn off the Guitar
While using a guitar effect, the use of dynamic effects is limited to one or two channels. To use dynamic
Effect or use two
effects on three or more channels, turn the guitar effect OFF.
or less Dynamic
Effects.
The working memory is full.
Even if the SD card has enough remaining space, this error could occur if you perform many editing
operations. You may be able to continue to work after executing the
Work Memory Full
SONG
39.)
Virutal Track has
Since a virtual track has been recorded, the track type cannot be changed. If you want to change it, clear
different Track
the recorded virtual track.
Type
menu to increase the amount of available working memory. (See "Undoing an operation" on page
Description and remedy
DELETE UNUSED
15 – Messages
item in the
69
TASCAM DP-32SD
Advertisement
Table of Contents
