Chroma Color Charge User Manual

Chroma Color Charge User Manual

Battery powered led fixture
Hide thumbs Also See for Color Charge:

Advertisement

Quick Links

Chroma-Q™
Color Charge™
User Manual
Version 1.4 September 2012, Software Version 1.7
PN: 618-0500

Advertisement

Table of Contents
loading

Summary of Contents for Chroma Color Charge

  • Page 1 Chroma-Q™ Color Charge™ User Manual Version 1.4 September 2012, Software Version 1.7 PN: 618-0500...
  • Page 2 (c) by operation outside the specifications contained in the user documentation; (d) by the use of spare parts not manufactured or sold by Chroma-Q or by the connection or integration of other equipment or software not approved by Chroma-Q unless the Customer provides acceptable proof to Chroma-Q that the defect or damage was not caused by the above;...
  • Page 3 Chroma-Q products are safe, effective, and fully satisfactory for the intended end use. Suggestions of use shall not be taken as inducements to infringe any patent. Chroma-Q sole warranty is that the product will meet the sales specifications in effect at the time of shipment.
  • Page 4: Table Of Contents

    ………………………………………………………..… 5 Battery …………………………………………………………. 5 Control …………………………………………………………. 5 DMX Protocol …………………………………………………………. 10 Pre-Programmed Looks …………………………………………………………. 11 Troubleshooting ………...……………………………………….………... 11 Specification ……………...…………………………………………………….………... 12 Technical specification …………………………………………………………. 12 Drawings ……………………………………………….…………. 13 Maintenance ………...……………………………………….………... 13 www.chroma-q.com Color Charge User Manual V1.4 September 2012...
  • Page 5: Product Overview

    The Color Charge battery powered LED fixture is an ultra portable, RGBA 600 hot lumen light source, which combines wireless control with an advanced feature set. The Color Charge is powered by an internal rechargeable NiMH battery pack with an operating capacity of up to 30 hours, and a product life of up to 1000 battery recharges.
  • Page 6: Mounting

    Mounting The Color Charge is designed primarily for floor mounting with an optional provision for truss mounting at the bottom of the chassis. For truss mounting, we recommend the use of a ½"-13UNC x ¾" long bolt to avoid damage.
  • Page 7 Power-Up Display: On power-up the display shows the model name “Color Charge” and software version V### for 5 seconds, then proceed to the main menu or home position showing in Figure 1 - the battery capacity in percentage (100), length of battery life in number of days (07day) or hours and minutes (00h00), control mode (RGBA), DMX status (Wired/WirelessDMX On/Off), and DMX address (002).
  • Page 8 Simple, with DMX console. Set the Color Charge to the desired ‘DMX1 Look Select’. Use a DMX console to adjust channel levels and create the desired look or effect. Press Up/Down buttons to access Look Store and press Enter.
  • Page 9 Press Up/Down to access ‘DMX Levels’ then press Enter to display the Channel Number, level (0-255), colour or ‘off’. Information This menu indicates the voltage (BatV), current (BatI) and temperature (BatT) of the internal battery pack and www.chroma-q.com Color Charge User Manual V1.4 September 2012...
  • Page 10 Unlink the transmitter to clear previous wireless connections. Initiate signal/link search after the Color Charge receiver unit is set. To activate the wireless DMX connection between a Color Charge unit as the Transmitter and the next Color Charge unit as the Receiver: Setup the Color Charge as the Receiver unit: From the main menu, press Up/Down to access ‘Wireless W-DMX’.
  • Page 11: Dmx Protocol

    Note: The Color Charge transmitter unit that is not connected to DMX control console continues to send wireless signal link to the Color Charge receiver units. The display of the receiver units will show ‘Wireless On’ and the horizontal bars beside it (4 bars maximum).
  • Page 12: Pre-Programmed Looks

    1 DMX channel 4 DMX channels Pre-Programmed Looks The Color Charge has 20 internal pre-programmed looks that are set as default. They can be modified and overwritten in the Look Store menu. Reset to Defaults menu will restore the looks. Look 1...
  • Page 13: Specification

    Symmetrical direct illumination CCT: Adjustable 1000 – 10000K CRI: Lamp Life: L70 up to 50,000 hours IP Rating: IP20 Operating temperature: 0º C to 40º C Approvals: CISPR 22:2006/EN55022:2006 (CLASS A) CISPR 24:1997/EN55024:1998 (+A1+A2) www.chroma-q.com Color Charge User Manual V1.4 September 2012...
  • Page 14: Drawings

    140mm / 5.5” Maintenance With care, the Color Charge will require little maintenance. However, as the unit is likely to be used in a stage environment we recommend periodical internal inspection and cleaning of any resulting dust and cracked oil residue.

This manual is also suitable for:

Chccrgba

Table of Contents