Headlamp Adjustment Diagram - Dnepr MT10-36 Operating Instructions Manual

-speedometer with lighting lamp, master switch with the key are fit-
ted on the dashboar.d.
When parking the motorcycle, never leave the ignition cut in sin-
ce the storage battery may discharge through the primary winding
o f the ignition coil, thus causing damage not only to the batte ry, but
.a lso to t he ignition coil (causing t he latter to be burnt out) .
To correctly install the headlamp, proceed as follows:
install the motorcycle (with a load) on a fl at ground in front of
.a
white wall or screen, at 10 m dis tance from the headlamp glass
to
the wall (Fig. 36);
Fig. 36. Headlamp adjustment diagram
slacken the bolts securin g the headlamp and adjust the latter to
such a pos ition at which 11:he axis of t he high beam is set horizontal-
ly, i- ·e. the centre of the light spot on the screen and the centre of the
headlamp are at an equal distance from the ground;
now check the lower beam. The upper boun dary of the light spot
projected onto the screen must be not less than 10 em below the
h eadlamp centre (with the lower beam filament switched on);
secure the bolts fas teni ng the headl amp.
Provid ed at the front an d rear of
the motorcycle are turn indicator lamps
YIT22313 with orange-coloured light
filters and bulbs .A l2-21 (Fig. 37). The
motorcycle on its rear wheel mudguard
is fitted with ru.by-,coloured lamp
<I>IT246 with bulbs Al2-21 ,and Al2-3,
the la mp has a tra nsp arent organic
glass fi tted in its lower part for ligtht-
ing up the number plate.
Provided at the front of 11:he sidecar
fender is a two-section lamp IT<P23213,
Fig. 37. Turn indicator
lamp YI1223B:
with bu ib A12-8 (Fig. 38) fitted in the
/-bulb A 12 _ 21 ; 2 -diffuscr:
3
_
white filter section, and bulb A 12-21 in
screw:
4 -
gasket:
s-
body
the orange filter section. At the side-
car rear is a two-section lamp <PIT219l3 (Fig. 39) with bulb Al2-2 l
fitted in the orange filter section, and bulb Al2-21+6 in the ruby
filter secti on.
75