Initial Start-Up - optris PI160 Operator's Manual

____________________________________________________________________________________________________________

8. Initial start-up

Please install at first the software PI Connect from the CD.
Note
Further information regarding software installation as well as software features you will find in the
manual supplied on the CD.
Now you can connect the infrared imager into an USB port (USB 2.0) of your PC.
Note
If connecting the imager and the computer please plug at first the USB cable into the camera and
then into the computer.
If disconnecting the imager and the computer please remove at first the USB cable from the
computer and then from the camera.
After the software has been started, you should see the live image from the
camera inside a window on your PC screen.
Note
At first start of software you will be asked to install the calibration
data of camera (supplied on the CD).
The sharpness of the image can be adjusted by turning the exterior lens
ring at the camera.
____________________________________________________________________________________________________________
optris PI – E2011-11-A
21