Electrical Installation - optris PI160 Operator's Manual

____________________________________________________________________________________________________________

7. Electrical Installation

At the back side of the PI you will find two connector plugs. Please connect the supplied USB cable with the
right plug. The left connector plug is only used for the process interface.
Backside of camera with
connectors
Process Interface
The PI is equipped with a process interface (cable with integrated electronics and terminal block), which can
be programmed via the software as an Analog Input (PIF in) and Digital Input (Dig In) in order to control the
camera or as an Analog Output (PIF out) in order to control the process. The signal level is always 0-10 V.
Note
Please make sure that the process interface (electronics within cable as well as industrial interface)
is powered separately (5-24 VDC).
____________________________________________________________________________________________________________
18
optris PI – E2011-11-A
Plug for USB cable
Plug for PIF cable