Lorex LNR100 SERIES Instruction Manual page 153

18 LNR100 Series Hard Drive Installation
3. Loosen the hard drive screws (4x), but do not remove them.
4. Carefully turn the NVR over and remove the cover. The easiest way to do this is to pull
up on the edge that hangs over the rear panel of the unit.
5. Disconnect the SATA power and data cable from the hard drive.
6. Slide the hard drive towards the front of the NVR and remove it from the unit.
7. Replace the cover and cover screws (6x).
Note
After installation, you must format the hard drive in order to use it with the system. See 18.3 Format-
ting Hard Drives, page 144.
#; r. 1.0/14396/14396; en-US
143