Fitting The Floor Tool; Tipping The Brush Deck - Nacecare TT 1117 / 100 Owner's Instructions Manual

Tipping the Brush Deck

Fig 7
!

Fitting the Floor Tool

The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor tool gets snagged, whilst in transit.
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Note:
To tip the deck into the down position
(Operating mode). Press in the brush
deck locking bar (Fig 7) and rotate the
brush deck (Fig 8).
To change to brush deck up position,
(Transit mode) simply lift the deck and
the sprung loaded locking bar will active
Fig 16
to hold the deck up.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Fit the floor tool and retain using
the detent pin (fig 9).
The lifting strap is held by a
detent pin (Fig 10).
Fig 9
Raise the floor tool for transit or lower for cleaning operation using the lifting
handle fitted to the back of the machine (Fig 11).
For fitting the floor tool blades (See Page 10)
Fig 11
Raise floor-tool again before driving to the cleaning area
8
Machine Set-Up
Fig 8
Fig 10