Lowering The Floor Tool; Pre-Scrub Mode - Nacecare TT 1117 / 100 Owner's Instructions Manual

Pre-cleaning advice.
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig 13).
Numatic part (629044) Wet Floor sign
(available if required)
!

Pre-scrub mode

The TT Range have been designed to cope with a variety of floor types and different levels of soiling.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position, allow the chemical time to work, then scrub the area a
second time with the floor-tool lowered.
Floor tool in use

Lowering the floor tool

Fig.16
After preparing the floor (see previous section), we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
Move the Floor tool lever (see fig.16), to it's lower position (see fig.17).
Note: The machine will still reverse with the floor tool in the lowered position, this could possibly damage the
blades. Raise the floor tool before reversing.
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
The clean-water / chemical mix is
dispersed via 'THRU-FEED' system.
The waste water is then retrieved by
the floor-tool.
Overlap the scrubbing path by 10cm
to ensure an even clean (Fig 14).
If streaking occurs, wipe the floor-tool
Fig 14
blades clean (Fig 15).
Machine Operation
10
Fig 13
!
Fig 15
Fig.17