Table of Contents
Advertisement
INSTALLATION GUIDE
Setting
Comp Heat Delta Stage 1 On
Indoor Heat Delta Stage 1 On
Indoor Heat Delta Stage 2 On
Comp Heat Delta Stage 1 Off
Comp Heat Delta Stage 2 Off
Indoor Heat Delta Stage 1 Off
Indoor Heat Delta Stage 2 Off
Cooling Delta Stage 1 On
Cooling Delta Stage 1 Off
Recovery Enable
Once all selections have been made, press the Done button to exit and return to Menu. Press Next to navigate to the next setting.
Setting
Blower On Delay Cooling
Blower Off Delay Cooling
Blower On Delay Heating
Blower On Delay Heating
Blower Off Delay Heating
Blower Off Delay Heating
Once all selections have been made, press the Done button to exit and return to Menu. Press Next to navigate to the next setting.
Restore Defaults
Restore Defaults is used to restore the control to factory default settings. To access "Restore Defaults" press the "Menu" button, then
press and hold "Next" for approximately 5 seconds, until Service" is displayed. Now press Select until "Installer Settings" is displayed.
Press Next until "Restore Default" is displayed. Now press Select again to enter "Restore Default". The default setting will be shown in
brackets. After each selection press Done to save changes.
Setting
Restore Default
Note: To reset all User, Installer and Z-Wave settings, press and hold the "Yes" button for 5 seconds. Release when "Factory Defaults" is
displayed. "Done" will be displayed once all settings have been restored and the control will automatically return to the home screen..
8
Menu Item: Comfort Settings
Range
.5 - 8 Degree
.5 - 8 Degree
1 - 8 Degree
0 - 8 Degree
0 - 8 Degree
0 - 8 Degree
0 - 8 Degree
.5 - 8 Degree
(-) 2 - (+)6
Yes, [No]
Menu Item: Airflow Settings
Range
[0] - 30 seconds
[0] - 90 Seconds
[0] - 30 Seconds
[0] - 60 Seconds
[0] - 90 Seconds
[0] - 90 Seconds
Menu Item: Restore Defaults
Range
Yes, [No]
Select the delta on for 1st stage compressor heat
Select the delta on for 1st stage indoor heat
Select the delta on for 2nd stage indoor heat
Select the delta off for 1st stage compressor heat
Select the delta off for 2nd stage compressor heat
Select the delta off for 1st stage indoor heat
Select the delta off for 2nd stage indoor heat
Select the delta on for 1st stage cooling
Select the delta off for 1st stage cooling
When enabled, will start the cooling or heating system so that the desired
comfort temperature is reached by the next scheduled set point time. The
advance start time calculation is a learned process that is recalculated and
adjusted each day until the room temperature is at the target temperature
at the schedule time. When the thermostat is in Recovery mode the
display will show "Recov". While in Recovery the Aux-Heat stage will not
engage. The maximum Recovery time is one hour.
(Non-Variable Speed blower only) Select the cooling blower on delay
(Non-Variable Speed blower only) Select the cooling blower off delay
(Non-Variable Speed blower only) Select the compressor heating
blower on delay
Select the hydronic heating blower on delay
(Non-Variable Speed blower only) Select the compressor heating
blower off delay
Select the hydronic heating blower off delay
Select "Yes" to restore all the User and Installer settings to the
factory defaults. If "Yes" is selected "Restoring" will be displayed.
"Done" will be displayed once all settings have been restored.
Description
Description
Description
18-HD46D1-1
Hide quick links:
Advertisement
Table of Contents
