Related Manuals for Trane TCONT401AN21MA
Summary of Contents for Trane TCONT401AN21MA
- Page 1 XR401 Comfort Control TCONT401AN21MA Comfort Control Owner’s Manual Mode Filter/OD...
- Page 2 Parts will be provided by our factory organization or an authorized service organization in your area. All you need to do is look us up in the Yellow Pages or write to the address given below. If you wish further help or information concerning this warranty, contact: Trane Troup Highway Tyler, Texas 75711-9010...
-
Page 3: Warranty
Warranty Limited Warranty Low Voltage Comfort Control This warranty is extended by Trane to the original purchaser and to any succeeding owner Comfort Control of the real property to which the is originally affixed, and applies to products purchased and retained for use within the U.S.A. and Canada. -
Page 4: Keypad Functions
Keypad MODE Functions - Pressing this key changes the system mode to Heat, Emergency Heat, Cool, Mode Automatic or Off. NOTE: Emergency Heat available only on Heat Pump applications. A border will appear around the mode on the display to show the system mode you’ve selected. Mode Page - 4 Pub. -
Page 5: Troubleshooting
Trouble Table 2 Troubleshooting -shooting Symptom Possible Cause Action 1. Blown fuse or tripped circuit breaker. 1. Replace fuse or reset breaker. 2. Turn switch to ON. 2. Furnace power switch OFF. Display will not come on. 3. Furnace blower compartment door or panel 3. -
Page 6: Setup Options
Keypad Functions - Pressing this key selects whether the indoor fan motor runs in automatic or (cont-) continuous mode. The FAN ON indicates that you have selected to operate the fan in continuous mode. Pressing the Fan keypad button again returns the indoor fan mode of operation to automatic and FAN ON goes away. -
Page 7: User Setup
User Entering User Setup: Setup Press and hold the MODE and FAN keypad buttons at the same time. Options Keypad Navigation: - Use the MODE or FAN buttons to navigate forward and backward through the Setup steps. - Press MODE to advance forward to the next step. - Press FAN to return to the previous step. -
Page 8: Factory Default Settings
Keypad FILTER/OD Functions - Press this key twice to display how many days remain before time to replace or Filter/OD (cont-) clean the filter. The “FILTER/OD” indicator will flash on the display when the filter timers days remaining reaches zero. Filter/OD - Press the “FILTER/OD”... - Page 9 Features Calibrate Outdoor Temperature This option allows calibration (or deliberate miscalibration) of the outdoor temperature (cont-) sensor. The selected number is number of degrees, plus or minus, which will be added to actual temperature. The number can range between + 5 and - 5 degrees in 1/2 degree incre- ments.
- Page 10 Keypad Energy Savings Functions (cont-) - Use this key to lower your systems energy consumption and save money at the same time! Pressing the Energy Savings keypad button changes the indoor tempera- ture setting to a warmer temperature when the system is operating in the cooling mode and to a cooler indoor temperature setting when operating in the heating mode.
- Page 11 Filter Reminder Features “FILTER/OD” will automatically flash to remind the homeowner that its time to change the (cont-) filter once the preset time has expired. Pressing the “FILTER/OD” keypad button automati- cally resets the internal clock timer. Once the timer has been reset, the number of days remaining till the next filter change can easily be determined by simply pressing the “FIL- TER/OD”...
- Page 12 Auto Changeover When the system mode is set to Auto, the control automatically switches between heating and Features cooling modes to maintain the desired comfort level. Appears when equipment is energized. Adjusting to new setting Setpoint Deadband The number of degrees separating Heating and Cooling setpoints. Neither the heating or cooling system operate when the indoor temperature is within the deadband.