About; Clean Screen - Trane TZEMT524AA21MA Installation Instructions And User Manual

USER GUIDE
If you need to remove the 524 Control from a Nexia™ Home Intelligence account, follow these exclusion steps.
This will disable remote access. If you are unsure, please contact Nexia support at 877-288-7707.
Install a fully charged, quality 9-volt battery into the Bridge.
1. Hold the Bridge within 6 feet (1.8 meters) of the 524 Control throughout the entire exclusion process.
Î After you begin the exclusion process, you have 30 seconds to complete the remainder of the steps. Study the steps below
before beginning.
2. Press and release the minus (-) button on the bridge.
3. Press MENU on the 524 Control.
Press NEXT to scroll to Z-WAVE screen then press SELECT.
4.
5. Press YES to exclude the control.
6. Observe the lights on the Bridge. The orange light will blink while exclusion is taking place. Exclusion is complete when the orange
light becomes solid.
Î Z-Wave™ controllers from various manufacturers may support the Z-Wave™ Thermostat General V2 Device class used
by the Z-Wave™ control. If you are using a controller that is not a Nexia bridge, consult the instructions that came with the
controller to find out how to enroll and exclude devices.
Installer Settings
Installer settings are described earlier in this document.

About

Setting
Version
Z-WAVE Ver
Node - ID
Home - ID
Out - Type
C/O - Type
In - Type

Clean Screen

Setting
Clean Screen
Once all selections have been made, press the Done button to exit and return to Menu. Press Next to navigate to the next setting.
14
Menu Item: Exclude from Net
Current firmware version loaded on the control
Current version of the Z-WAVE firmware
Z-WAVE identification for this device
Z-WAVE identification for the connected Z-WAVE network
Identifies the type of outdoor unit installed
Indicates whether the reversing valve is energized in cooling or heating mode
Identifies the type of indoor unit installed
Range
Yes, No
About
Description
Clean Screen
Selecting yes allows the user to clean the screen without activating any
of the onscreen touch points. Use only water and a soft cloth, no harmful
chemicals.
Description
18-HD46D1-1