Wiring Of The Rear Panel Connector - piezosystem 12V40 Series Instruction Manual

7.8. Wiring of the rear panel connector

To realize OEM applications, all main control signals are also available at the
rear panel connector.
Pin name
1,4 GND
2 VCC
6 MON
7 MOD
8 SRC
12 OUT
15 GND
16 PWR
table 2: pin wiring of the rear panel connector (12V40 / SG / CLE)
* option: is set at the factory, must be specified when ordering
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
28
description
ground (Signal)
+5 V output, for switching SRC
monitor signal 0...+10 V
modulation input 0...+10 V
source, choice of the amplifier control by HIGH or LOW
TTL level
HIGH: Pin 7 is active, OFFSET potentiometer and MOD
(modulation input) at the front panel are switched off
LOW: Pin 7 is not active, motion of the actuator will be
controlled by the OFFSET potentiometer and the MOD
(modulation input) at the front panel
output voltage -10...+150 V (* option)
ground (operating voltage)
+ operating voltage