Keyboard - HP ENVY m6 Maintenance And Service Manual

Keyboard

NOTE: The keyboard spare part kit includes a keyboard cable.
For use in country/region
For use in Canada
For use in Japan
For use in Latin America
For use in South Korea
Before removing the keyboard, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Base enclosure (see
d. System board (see
e. Connector board (see
f. Subwoofer (see
g. Rear speaker (see
h. Power button board (see
Remove the keyboard:
1. Remove the seven Phillips PM2.0×2.9 screws (1) that secure the keyboard shield to the computer.
2. Release the ground loop tape (2).
Keyboard in natural silver finish with backlight (includes keyboard cable and backlight cable):
760743-DB1
760743-291
760743-161
760743-AD1
Battery on page
WLAN module on page
Hard drive on page
Base enclosure on page
System board on page
Connector board on page
Subwoofer on page
Speakers on page
Power button board on page
For use in Taiwan
For use in Thailand
For use in the United States
34), and then remove the following components:
35)
38)
45)
56)
64)
66)
68)
72)
Component replacement procedures
Spare part number
760743-AB1
760743-281
760743-001
73