Mail - D-Link DCS-935L User Manual And Service Information

Section 3 - Configuration
This section allows you to configure your camera to send snapshots and video clips to an e-mail address. If you are not sure what settings to use,
check with your e-mail service provider.
SMTP Server
This is the domain name or IP address of your external e-mail server.
Address:
SMTP Server This is the port used by your external e-mail server.
Port:
Sender e-mail
This is the e-mail address listed as the sender for your notification e-mails.
Address:
Receiver e-mail
This is the e-mail address that your notification e-mails will be sent to.
Address:
User Name: If the SMTP server uses authentication, enter your user name.
Password:
If the SMTP server uses authentication, enter your password.
Use SSL-TLS/ If your SMTP server requires SSL-TLS or STARTTLS, select it here.
STARTTLS
For example, if you want to use Gmail with SSL-TLS for e-mail notifications, you
can follow the setup procedure as below:
Step 1 - Enter "smtp.gmail.com" in SMTP Server Address.
Step 2 - Change the SMTP server port number from 25 to 465.
Step 3 - Enter your gmail e-mail address in Sender E-mail Address.
Step 4 - Enter the destination e-mail address in Receiver E-mail Address.
Step 5 - Enter the user name required to access the SMTP server.
Step 6 - Enter the password required to access the SMTP server.
Step 7 - Select SSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail will be sent.
Note: You can also use STARTTLS, which will use SMTP server port number 587.
If you want to use a Yahoo SMTP server, the SMTP server address will be different
between each registered region, and only SMTP port 465 is supported for SSL-
TLS.
D-Link DCS-935L User Manual

Mail

33