Mail - D-Link DCS-930L User Manual

Section 4 - Configuration
This section allows you to configure the email notification settings for your camera.
SMTP Server Address:
This is the domain name or IP address of your external e-mail server.
Sender e-mail Address:
This is the e-mail address of the person sending the camera snapshots.
Receiver e-mail Address: This is the e-mail address of the recipient.
User Name: If the SMTP server uses authentication, you must enter your user
name here.
Password:
This is the password that corresponds to your user name to connect
to the SMTP server.
For example, if you want to use Gmail by SSL-TLS for the e-mail notification, you can follow the
setup procedure as below:
Step 1 - Enter "smtp.gmail.com" in SMTP Server Address.
Step 2 - Change the SMTP server port number from 25 to 465.
Step 3 - Enter your gmail E-mail address in Sender E-mail Address.
Step 4 - Enter the destination E-mail address in Receiver E-mail Address.
Step 5 - Enter the user name required to access the SMTP server.
Step 6 - Enter the password required to access the SMTP server.
Step 7 - Select SSL-TLS and then click Save Settings.
Step 8 - Click the Test button to send a test e-mail will be sent to the e-mail account listed above.
Note: You can also use STARTTLS which will use SMTP server port number 587.
Note: If you want to use the Yahoo SMTP server, the SMTP server address will be different between each registered region. And it only supports the SMTP server
port number 465 for the SSL-TLS.
D-Link DCS-930L User Manual

Mail

31