Lighting Instructions - Napoleon BIPRO 825 User Manual

Lighting Instructions

Smoker Burner
Igniter
Left
Rear
Tube Burner
Burner
WARNING!
Open lid
WARNING!
Ensure all burner controls are in the off position. Slowly turn on the
gas supply valve.
Main Burner
Lighting
1. Open grill lid.
2. Push and turn any main 2. Push and turn the smoker
burner knob to the high
position. If the pilot lights,
continue to push down on the
control knob until the burner
lights and then release.
3. If the pilot does not ignite,
then immediately turn the
control knob back to the 'off'
position and repeat step 2
several times.
4. If the pilot and burner will
not ignite within 5 seconds,
turn the control knob to
the 'off' position and wait 5 the 'off' position and wait 5
minutes for any excess gas to minutes for any excess gas to
dissipate. Either repeat steps
2 and 3 or light with a match.
5. If lighting the unit with a
match, clip the match into the
supplied lighting rod. Hold
the lit match down through
the grill and sear plate while
turning the corresponding
burner valve to high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use rear burner while operating main burner.
Left Right
Right
Smoker
Centre Centre
Tube
Tray
Tube
Tube
Burner
Burner Burner
Smoker Burner Rear Burner Lighting
Lighting
1. Open grill lid.
2. Remove warming rack.
burner control knob to the
high position.
3. Push and hold the 3. Push and turn the rear
electronic igniter button burner control to the high
until the burner lights, or
light with a match.
4. If the burner will not 4. Push and hold the
ignite within 5 seconds, electronic igniter button
turn the control knob to until burner lights, or light
dissipate. Repeat step 2.
5. If the burner will not
ignite within 5 seconds,
turn the control knob to
the 'off' position and wait 5
minutes for any excess gas
to dissipate. Repeat step 3.
Left
Right
Warming
Infra
Infra
Burner
Red
Red
Burner
Burner
Off Position
Side Burner Lighting
(if equipped) (if equipped)
1. Open grill lid. 1. Open burner cover.
2. Push and turn the side
burner control knob to the high
position.
3. Push and hold the electronic
igniter button until the burner
position. lights, or light with a match.
4. If the burner will not ignite
within 5 seconds, turn the
control knob to the 'off'
by match. position and wait 5 minutes
for any excess gas to dissipate.
Repeat step 2.
www.napoleongrills.com
7
EN
Light