Dynamic SoundField Installation Instructions DigiMaster X www.phonak.com 1. Setup DigiMaster X is a Dynamic SoundField receiver that upgrades an amplification system to intelligent dynamic behavior. This guide is aimed at professional installers. DigiMaster X Power adapter Audio cable Product description www.phonak.com...
Dynamic SoundField Installation Instructions DigiMaster X Placement The distance between the DigiMaster X and the room’s existing amplifier system should be as short as possible. The power supply for the DigiMaster X and the power supply for the amplifier can be fed from the same mains. ...
Dynamic SoundField Installation Instructions DigiMaster X Connection to amplification system Mic input = 3.5 mm mono jack 3.5 mm Jack cable Mic input = 6.3 mm <-> ¼ inch mono jack 3.5 mm <–> 6.3 mm Jack adapter Mic input = XLR 3.5 mm <->...
Page 4
Dynamic SoundField Installation Instructions DigiMaster X Connection to computer (recording) and amplification system Mic input = 3.5 mm mono jack Y- jack splitter Mic input = 3.5 mm Caution: such connections may cause hum. Connection to Grommes-Precision XAV-102-A The gain of the microphone input is set by a potentiometer on the Wall Plate Remote Module. Precautions should be taken to prevent gain changes.
Page 5
Dynamic SoundField Installation Instructions DigiMaster X Connection to RDL FP-PA20A AUDIO AMP Audio from DigiMaster X...
Page 6
Dynamic SoundField Installation Instructions DigiMaster X Connection to Calypso CA-1000 The CA Config software program is required to set the gain of the CA-1000. Terminate the 2-pin Phoenix connector to the CH4+/CH4-(Bal) series-socket as depicted above. Identical values Shielding The screenshot show: ...
Need help?
Do you have a question about the Dynamic SoundField DigiMaster X and is the answer not in the manual?
Questions and answers