Setting Up Your Litter-Robot - Litter-Robot II Standard Unit Manual Manual

Setting Up Your Litter-Robot

1. Place the Litter-Robot in the same location as the
old litter box, if possible. Make sure the Litter-
Robot is placed on a level, firm surface.
2. Put the Globe on the Base with the Cat Entry
opening facing the front as shown in the picture
below. Make sure that the track on the Globe
engages with the gear in the Base unit
Globe
Cat Entry/Exit
Control Panel
Waste Drawer
Shown in Home Position
3. Plug the small connector from the AC adapter into
the socket in the back of the Base unit. Next, plug
the main power cord into a wall outlet. Press the
ON/OFF Switch - the Litter-Robot will perform an
initialization cycle (this takes about 3 minutes).
After completing the cycle, the Globe should be in
the "home" position with the green light on.
Toll Free: 877-250-7729
.
Waste Ports
Power Cord
ON/OFF Switch
Base
www.Litter-Robot.com 7
4. Now fill the Globe with litter. The Litter-Robot litter
sifting system requires a clumping type litter to
work properly. The Litter-Robot is also compatible
with corn based World's Best Cat Litter
beads, and crystals can also be used with the Litter
Robot as long as the beads and crystals are small
enough to pass through the screen – periodic
changing of this type of litter is required. Litters
that DO NOT work in the Litter-Robot are the
strictly absorbent, non-clumping litters, newspaper
based litters, and Feline Pine Absorbent Pellets. If
you are using a litter alternative not listed here, you
can contact us at help@litter-robot.com
sure you are using a compatible litter.
If you are filling the Litter-Robot for the first time
we recommend that you do not switch litter brands
at this time. Your cats need to get used to this new
litter box and introducing a new kind of litter may
increase their level of apprehension. However, if
you are currently using a non-clumping litter you
will need to switch to a clumping style litter.
Litter can be added to the Globe in two ways:
 Filling through the entry/exit opening (A)
 Filling through the square waste ports (B)
A. Filling through the entry/exit opening
To facilitate filling the globe through the entry/exit
opening, disengage the globe from the gear and
simply rotate the globe back and away from you
8 Toll Free: 877-250-7729
. Litter
to make
www.Litter-Robot.com