Summary of Contents for Litter-Robot II Standard Unit
Page 1
Litter-Robot™ II Manual Standard Unit For Standard and ‘Bubble’ Units The Self-Cleaning Litter Box that Really Works! ‘Bubble’ Unit Toll Free: 877-250-7729 www.Litter-Robot.com Toll Free: 877-250-7729 www.Litter-Robot.com...
Litter-Robot operate in automatic mode. Testing the Cat Sensor ........24 Make sure the Litter-Robot is placed on a level firm Adjusting the Cat Sensor Sensitivity ....22 surface. Placing the Litter-Robot on deep carpet Safety Features ..........29 may require adjusting the cat sensor (more Cleaning and Maintenance ......
Try the Litter-Robot in your home for 90 days. If you or your cats are not completely satisfied, for any reason, simply return the Litter-Robot within 90 days for a full refund.
Globe Waste Ports If you are filling the Litter-Robot for the first time we recommend that you do not switch litter brands at this time. Your cats need to get used to this new...
Page 5
‘Fill Line’ ring (see figure below). After adding litter to the Litter-Robot you can start a cleaning cycle by pressing the “Cycle” button on the Control Panel or by turning the unit OFF then ON with the switch on the back of the Base.
Page 6
To ensure that your cats ease into this new litter Next, grab the handle of the Internal Guard and box experience, you can turn the Litter-Robot OFF rotate it downward (counter-clockwise). This closes for a few days to give your cats sufficient time to the Internal Guard.
If your cats are not using the Litter-Robot within a Getting Your Cat to Use the Litter-Robot few days, continue using the old brand of litter in the old litter box, and let it go as long as possible Most likely, your cat will quickly adapt to the Litter- without cleaning it.
Pressing the "Cycle" button starts the Litter-Robot Yellow Light (“Cycling/In Use”) cleaning cycle. To stop the cycle, press any button The Litter-Robot is cycling (Cleaning cycle, Fill cycle, on the Control Panel. Press "Cycle" once again to or Empty cycle).
The Control Panel Lockout Feature prevents children (or your pet) from pressing the buttons Your Litter-Robot is shipped with a 10 gallon trash and cycling the unit unnecessarily. However, the bag already installed in the waste drawer - two extra Litter-Robot will continue to function normally in the trash bags have been provided.
Installing the Lip Extender If the Lip Extender did not come assembled to the Globe, or if you need to reassemble it, please follow the instructions below: Toll Free: 877-250-7729 www.Litter-Robot.com Toll Free: 877-250-7729 www.Litter-Robot.com...
Page 11
Soaking of the Control Panel in either water from cleaning, or urine from a cat continually missing the litter may damage the circuit board. Lip Extender Installed Toll Free: 877-250-7729 www.Litter-Robot.com Toll Free: 877-250-7729 www.Litter-Robot.com...
Your cat must be at least five (5) lbs for the sensor to work. Do not use the Litter-Robot with 2. Make sure that the green light on the Litter-Robot kittens or cats that weigh less than five lbs. Control Panel is on (“OK/Waiting”).
1. Make sure that the Globe contains the desired activating when your cat enters the Litter-Robot, amount of litter before adjusting the sensor then the cat sensor is not sensitive enough and sensitivity.
Page 14
Base unit and turn the Rotatable Foot to the left should not normally be necessary. (about 2 full turns at a time – see figure). Make sure the Litter-Robot is placed on a level firm surface. Placing the Litter-Robot on deep carpet may require adjusting the cat sensor (more sensitive).
Litter-Robot Globe starts rotating back to the home The Litter-Robot comes equipped with an anti-pinch position, the Internal Guard automatically closes, feature to make the Litter-Robot extra safe for your cat. covering the waste ports again. If a potential pinch condition is detected, the Globe automatically stops and then reverses direction for approximately 2 seconds.
If some litter remains in the Globe, you may want to sweep the remainder out with a brush. Before you clean the Litter-Robot please make sure that you remove all litter from the Globe - wet litter turns Cleaning the Globe into messy clay.
If you or your cat are not completely satisfied with the filter pad for absorbing odors in the drawer. The carbon Litter-Robot, just return the unit to us within 90 days for filter can be easily removed and replaced when cleaning a full refund of purchase price.
The old litter box can be left near the Litter-Robot for a short time. Take a cup of Toll-free: 1-877-250-7729 litter from the old litter box and add it to the clean litter in the Litter-Robot.
Page 19
If you and your cat are not completely satisfied, just No, the Globe will not turn while your cat is inside. The return your Litter-Robot within 90 days of purchase for a Cat Sensor is tripped each time a cat enters, or re-enters full refund of the purchase price.
Page 20
Does the Litter-Robot work with Feline Pine? How do I clean the Litter-Robot exterior? Cleaning the Litter-Robot exterior is easy. Just remove No, Feline Pine pellets are too large to pass through the the Globe and the Drawer and give them a sponge bath, sifting screen.
Control Panel will blink at a rate of If the Globe becomes jammed or if the rotation of once per second. Make sure the Litter-Robot is on a the Globe has become obstructed or interrupted level surface. If the condition persists, please several times, the motor will stop and all three lights contact Customer Service.
Page 22
Automated Pet Care Products, Inc. 40 W. Howard, Suite B-5 Pontiac, MI 48342 Toll Free: 877-250-7729 Fax: 248-253-1797 www.litter-robot.com Litter-Robot™ II Manual - Version 20120905...
Need help?
Do you have a question about the II Standard Unit and is the answer not in the manual?
Questions and answers