Litter-Robot II Standard Unit Manual Manual page 14

4. TO DECREASE THE SENSOR SENSITIVITY
To decrease the sensor sensitivity, lift the front of
the Base unit and turn the Rotatable Foot to the
right (about 2 full turns at a time – see figure).
5. TO INCREASE THE SENSOR SENSITIVITY
To increase the sensor sensitivity, lift the front of
the Base unit and turn the Rotatable Foot to the left
(about 2 full turns at a time – see figure).
Toll Free: 877-250-7729 www.Litter-Robot.com 27
6. Next, if it was removed earlier, slide the waste
drawer back into the Base unit and place the Globe
back on top of the Base. Now, test the function of
the Cat Sensor again.
If the red light stays on after attempting to reset the
unit, the Cat Sensor is too sensitive.
If red light does not come on when your cat enters
the Globe, the Cat Sensor is not sensitive enough.
7. The Cat Sensor may have to be re-adjusted several
times by rotating the Foot in increments of 1 to 2
full turns before the desired sensitivity is achieved.
Note: The cat sensor is set at the factory for
optimal performance for most cats. Adjustment
should not normally be necessary.
Make sure the Litter-Robot is placed on a level
firm surface. Placing the Litter-Robot on deep
carpet may require adjusting the cat sensor
(more sensitive).
If you need any help with adjusting the Cat
Sensor sensitivity, please call Customer Service,
toll-free, at 1-877-250-7729.
28 Toll Free: 877-250-7729 www.Litter-Robot.com