Download Print this page

Litter-Robot LR3 Connect Upgrade Kit Installation Manual

Download this manual

Upgrade Kit includes:

Litter-Robot Connect Circuit Board

Litter-Robot Connect Applique

QR code

nstallatIon

You will need:

Needle-nose pliers

Flathead screwdriver or blade

Press the Power button to turn the Litter-Robot off

and unplug it from the wall.

2. Remove the power supply plug from the rear of

the unit. Remove the bonnet and globe. Your Litter-

Robot base should now look like the base in the

photo.

3. Carefully remove the old blue applique using a

small flathead screwdriver or blade.

Contact Customer Service

Monday - Friday, 9am - 5pm EST

1-877-250-7729 or support@litter-robot.com

Connect Upgrade Kit Installation Guide

Visit www.support.litter-robot.com for installation videos.

4. Apply the new black applique to the control panel

cover.

5. Remove the waste drawer from your Litter-Robot

base and set it aside.

6. Open the control panel by removing the 5 screws.

LR3-8060-0e

Need help?

Do you have a question about the LR3 Connect Upgrade Kit and is the answer not in the manual?

Page 1 You will need: Needle-nose pliers Flathead screwdriver or blade Press the Power button to turn the Litter-Robot off 4. Apply the new black applique to the control panel and unplug it from the wall. cover. 2. Remove the power supply plug from the rear of the unit.
Page 2 Connect Upgrade Kit Installation Guide Visit www.support.litter-robot.com for installation videos. 7. Carefully remove the circuit board cover; take care 11. Install the rubber circuit board cover over the new not to lose any of the screws. circuit board. Make sure that it is securely fitted along all of the edges.
Page 3 Litter-Robot and connect to the app. 16. Remove the old serial number label from the back of your Litter-Robot base and apply the new label from your kit in its place. Please note: The app will not work with the old serial number, so you must complete this step.