Cleaning And Maintenance - Litter-Robot II Standard Unit Manual Manual

Cleaning and Maintenance

The Litter-Robot requires no special maintenance. We
recommend that you do not lubricate the four plastic
'glide buttons' on the Base unit. Lubricating these glide
buttons will cause dirt to build up.
Before you clean the Litter-Robot please make sure that
you remove all litter from the Globe - wet litter turns
into messy clay.
Emptying the Litter-Robot
Look through the Cat Entry opening and locate the
ribbed handle of the Internal Guard on the right, inside
the Globe. Rotate this handle upward (clockwise) to
lock the Internal Guard in the "open" position (see
figure). The Internal Guard is locked when the handle
snaps into a horizontal position. The waste ports on the
right side of the Globe are now open. Note that the pin
on the opposite side of the globe should be locked
behind the spring as shown below.
Locate Internal Rotate handle upward
Guard handle until it locks In position
Toll Free: 877-250-7729
Rear View
Pin Locks behind
spring
www.Litter-Robot.com 31
Press the "Empty" button to rotate the globe to the
discharge position, with the waste ports directed into the
drawer. After the litter has dumped into the waste
drawer, you can press any button on the Control Panel
to return the Globe to the home position.
If some litter remains in the Globe, you may want to
sweep the remainder out with a brush.
Cleaning the Globe
After removing all litter from the Globe, clean the Globe
with water and a mild soap. There are no electronic
components in the Globe which can be damaged by
soap and water. If the Globe has become extremely
dirty, it can be soaked or cleaned with a water hose. Be
sure that the Globe is completely dry before returning it
to the Base.
For a quick touchup, you can use a disposable towelette
to wipe the inside and upper half of the Globe. This can
be done without removing the litter. The Litter-Robot
can be used immediately after this touch-up because
drying is almost instantaneous.
Cleaning the Waste Drawer
The drawer can easily be removed and cleaned with
soap and water.
Cleaning the Base
Never submerge or soak the Base. The Base
contains the Cat Sensor and electronics. You can wipe
the surfaces of the Base with a cloth dampened with a
disinfectant.
32 Toll Free: 877-250-7729 www.Litter-Robot.com