Operations And Functions - Daewoo KOR-6L05 Service Manual

OPERATIONS AND FUNCTIONS

1. Connect the mains lead to an electrical outlet.
2. After placing the food in a suitable container, open the oven door
and put it on the glass tray. The glass tray must always be in
place during cooking.
3. Close the door securely.
4. Choose cooking power level by setting V.P.C knob to the desired
position. Refer to cookbook for recommended power levels.
5. Determine cooking time. Consult cookbook for recipe timing.
Oven light turns on and cooling fan starts to operate. Microwave
cooking starts.
6. You may open the door while the oven is operating. As soon as
the door is opened, the safety mechanisms stop the generation of
microwave power and the operation of cooking timer.
If you wish to change the time during cooking, simply adjust the
timer to the desired time.
7. When the timer reaches zero, a bell will ring and the unit will turn
off. Oven light turns off. If additional cooking time is needed and
the door is closed, the oven will automatically start when the timer
is reset.
Make sure the oven is properly installed and plugged into the electrical outlet.
Variable power cooking
ON and OFF cycle time of mechanical V.P.C switch is 30 seconds.
When the V.P.C knob is set to the desired position and timer knob to the desired position, the V.P.C switch has a cycle
(ON/OFF time(sec.)) listed below.
Variable power setting
Power level
HIGH
MEDIUM
LOW
DEFROST
WARM
NOTE
When setting timer for less than 10 minutes,
turn the timer past 10 minutes and
then return to the correct timer setting.
min
35
30
25
20
15
Approximate Percentage
7
0
1
2
3
4
5
6
7
10 8
9
of Power
100%
77%
55%
33%
17%