Nitek VR448COAX Installation And Operation Manual

Model VR448COAX
4-Port PoE Switch with Network Extender
Introduction
The VR448COAX Network Extender is designed to greatly extend the distances to which IP cameras and other
network devices can operate. The VR448COAX Network Extender consists of two units, a 4-port transmitter and a
receiver. Only the transmitter provides PoE to the connected network device. The receiver is installed at the NVR/IP
equipment side and the transmitter at the IP camera side of the installation.
Speed Speed Off Off 10 Mbs 10 Mbs
LED LED Green Green 100 Mbs 100 Mbs
10/100
POWER
ETHERNET
Status Blinking Establishing Link
LED On Link Established
Speed Speed Off Off 10 Mbs 10 Mbs
LED LED Green Green 100 Mbs 100 Mbs
10/100 Data 10/100
Note: A sticker on the bottom of each unit identifies whether it is the transmitter or the receiver.
NITEK
072110 681200106
Activity Activity Off Off No Network No Network
LED LED On On Network Detected Network Detected
Blinking Network Activity Blinking Network Activity
Data
LINK
Type
Status
COAX
Type On
LED Off
FRONT
TRANSMITTER
Activity Activity Off Off No Network No Network
LED LED On On Network Detected Network Detected
Blinking Network Activity Blinking Network Activity
Data 10/100 Data 10/100 Data
ETHERNET PORTS
FRONT
®
RECEIVER
Transmitter
Receiver
Status Blinking Establishing Link
LED On Link Established
POWER INPUT
48 VDC, 1 Amp max.
POWER
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: (847) 259-8900
Fax: (847) 259-1300
E-mail: info@nitek.net
WWW.NITEK.NET
Installation and

Operation Manual

Ground
Connection
COMMERCIAL
CCTV PRODUCT
40FE
E325724
NITEK
POWER INPUT
24 AC/DC
12-24 AC/DC, 0-100 Hz
R
Class 2 only, 1 Amp max.
BACK
Type On
LED Off
COAX
LINK STATUS
BACK
De Schans 19-21 2a
8231 KA Lelystad
Tel: +31(0)320-2300005
Fax: +31(0)320-282186
E-mail: info@nitek.nl
WWW.NITEK.NL
Ground
Connection
Transmitter
Receiver
NITEK
R