4.10 Check-Counting; 4.11 Check-Weighing - OHAUS BC Series Instruction Manual

BC Series

4.10 Check-Counting

Compares the quantity (count) of an item against a pre-set Hi-Lo range.
To initiate entering Hi-Lo parameters:
Press Hi/Lo. Enter the desired "Hi" limit value
(ex. 50), then press Hi/Lo to confirm. Enter
the desired "Lo" limit value (ex. 25), then
press Sample and exit to check-counting.
When a quantity of items placed on the pan is
within the Hi-Lo range, "-PASS-" is displayed.
The Count display also flashes and the check-
alarm will beep continuously within a preset
range (refer to Sec. 5.9).

4.11 Check-Weighing

Compares the weight of an item against a pre-set Hi-Lo range.
To initiate entering Hi-Lo parameters:
Press Hi/Lo. Enter the desired "Hi" limit value
(ex. 2000), then press Hi/Lo to confirm. Enter
the desired "Lo" limit value (ex. 1500), then
press APW and exit to check-weighing.
When a weight placed on the pan is within the
Hi-Lo range, "-PASS-" is displayed.
The Weight display also flashes and the
check-alarm will beep continuously within a
preset range (refer to Sec. 5.9).
NOTES:
To clear a displayed value, press C, then re-enter a new value.
A high limit value must be entered before the low limit can be effective.
Hi-Lo values are not retained when the unit is turned off.
Weight g Piece Weight g/pc
--Hi--
High (Hi) limit value
--Hi--
--Lo--
1500.0 -PASS-
Weight g Piece Weight g/pc
--Hi--
Displays High (Hi)
limit value
--Hi--
--Lo--
-PASS-
EN-10
Count
0.
Low (Lo) limit
value
50.
50.
Count
0.
Displays Low (Lo)
limit value
2000.
2000. 1500.
pcs
0.
0.
25.
pcs
0.
0.
25.