Initializing Your Gps Receiver; Using / Testing Your Gps Receiver - Globalsat ND-105X User Manual

4.INITIALIZING YOUR GPS DONGLE
Before using your GPS Dongle for navigation (especially for the first time), the
receiver must obtain a local GPS fix (coordinates) of the current position. To do this,
take your laptop (with your USB driver and the mapping software loaded and
configured) to an open area that has a clear view to the sky (such as a park or
empty field). Start your software (or the included GPS Info utility program) and wait
for initialization of the GPS to complete. This may take a few minutes depending on
various factors such as the distance of the current coordinates from the last time the
GPS Dongle was activated, GPS signal strength and surrounding terrain (tall trees
and buildings can block the satellite signals). Once the RAW GPS data is displayed
onto the screen, if applicable for your software, a fix has been initialized (red LED
on the GPS will also start to flash). In some cases initialization can take up to
several minutes depending on the conditions mentioned above before complete
GPS data will be displayed on the screen.
Coordinates scrolling with zero's means that the port connection is complete, but
the satellite data is not being received yet (possibly still initializing or in a bad area
for satellite reception).
5.USING / TESTING YOUR GPS DONGLE
Once the GPS Dongle's driver and your personal mapping software have been
installed and configured properly, you can begin to use your navigation system by
plugging the Micro USB GPS into your laptop's USB port and launching your
mapping software. If you don't have a mapping, or navigation software, we've
included a GPS test utility called "GPS Info" for the purpose of confirming your
installation and configuration. This utility can be installed by clicking the
GPSInfo.exe file from the Win directory on the CD-ROM or downloaded from our
web-site www.globalsat.com.tw.
LED Status indicator on the GPS Dongle " LED OFF: GPS receiver is off (no
power). LED ON (solid): No fix, searching for GPS signals. LED FLASHING:
Position fix established and GPS signals are being received.
Always select an area in the vehicle where the GPS unit will be secure and not
obstruct normal driving, visibility and safety, but still maintaining a "view to the sky"
in order to receive satellite data.
It is recommended that you first load and test your GPS Dongle with the
GPSinfo.exe. This process will confirm you have found correct COM port number
and have configured it properly.
1. Run GPSinfo.exe
2. Enter the proper COM port for your GPS device (see COM Port Verification
above)
3. Set COM port to Baud rate: 4800
4. If no errors have been made in configuration, there should be GPS data being
displayed in the window, which is confirmation that the communication between
the GPS device and the "GPSinfo" software is working properly.
to load the utility.
16F., No.186, Jian 1
- 7 -
GlobalSat WorldCom Corporation
st
Rd., Zhonghe Dist., New Taipei City,
Taiwan (FAR EAST CENTURY PARK)
TEL:886-2-8226-3799 FAX:886-2-8226-3899