4. INITIALIZING YOUR ND-100S............................. 6 5. USING ND-100S (Windows)............................6 ND-100S AP interface Description........................7 Starting using the ND-100S with AP ........................ 8 Cold Start / Hot Start / Warm Start ........................9 NMEA DATA Log.............................. 9 6. UNINSTALLING THE USB DRIVER and PC Utility(Windows)................. 11 7.
Works with Windows, Mac and Linux O/S notebooks and laptops. If you need navigation software, you can check-out www.usglobalsat.com under the Navigation Software section for recommendations. 1. GETTING STARTED There are only a few simple steps that you need to follow before using your ND-100S:...
NOTE: From within your mapping or navigation software (including the supplied GPS Information utility), you will need to manually configure the COM port that was assigned to the ND-100S GPS receiver so that proper communication between the GPS receiver and a mapping program can occur.
4. INITIALIZING YOUR ND-100S Before using your ND-100S receiver for navigation (especially for the first time), the receiver must obtain a local GPS fix (coordinates) of the current position. To do this, take your laptop (with your USB driver and the mapping software loaded and configurable) to an open area that has a clear view to the sky (such as a park or empty field).
ND-100S AP interface Description MENU Executable ND-100S Cold Start / Warm Start / Hot Start and set the format type of Log File MAP Portion When the notebook is connected with internet, ND-100S AP’s MAP is go to show world map.
Show the ND-100S Setting in NB COM PORT. Terminal Show the ND-100S receiving NMEA DATA. ★Note: If the notebook is not connected with internet, ND-100S AP’s MAP can not to show. Starting using the ND-100S with AP In the SETUP PAGE, click...
If ND-100S needs Cold Start. Just click function tab: Tools>Cold Start to get Cold Start. NMEA DATA Log ND-100S also provides a simple DATA Log feature. You can save it as TXT format or KML format ND-100S default Log File format is TXT File format.
Page 10
While ND-100S is plugged into the USB PORT and implement ND-100S AP on the NB, we can start ND-100S Log function. In SETUP portion, click then you can choose file folder to save log file. For example, Desktop. Click , bullet will change to .
Will the ND-100S work with Street Map, Marine Chart or Aviation software? Globalsat USB GPS receivers provide standard NMEA data for mapping software to use and convert to coordinates. Data from the ND-100S should work well with most any NMEA compliant software on the market today.
If you are parked in a covered parking lot or near a tall building, it is recommended that you drive away until you have a clear view of the sky before using the ND-100S. You may need to give the GPS a few minutes to find or get a fix its location.
9. SAFETY AND LEGAL NOTICES Please read this section carefully before using the GPS receiver Globalsat Technology Corporation / USGlobalsat, Inc. will not accept any responsibility whatsoever for accidents resulting from failure to observe common sense precautions. Your personal judgment, traffic regulations, and common sense must always take...
Page 14
In the event of a product defect during the first 30-days of the warranty period, return product and the sales receipt as proof of purchase date to place of original purchase. Defect discovered after 30-days from date of purchase, you must contact Globalsat/USGlobalsat’s Technical support for a Return Merchandise Authorization (RMA) number for return to manufacturer.
12. FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.