Serial Ata/Serial Ata Raid Connectors Controlled; By Ich5/Ich5R: Sata1, Sata2 (Optional) - MSI 865PE/G Neo2-P MS-6728 Manual

MS-6728 ATX Mainboard
Serial ATA/Serial ATA RAID Connectors controlled by ICH5/
ICH5R: SATA1, SATA2 (Optional)
The Southbridge of this mainboard is ICH5/ICH5R which supports two
serial connectors SATA1& SATA2.
SATA1 & SATA2 are dual high-speed Serial ATA interface ports. Each
st
supports 1 generation serial ATA data rates of 150 MB/s. Both connectors are
fully compliant with Serial ATA 1.0 specifications. Each Serial ATA connector
can connect to 1 hard disk device. Please refer to the Appendix B: Intel ICH5R
Serial ATA Raid Introduction for detail software installation procedure.
Serial ATA /Serial ATA RAID Connectors controlled by VIA
VT6420: IDE3, SATA3 & SATA4 (Optional)
The brand new VIA VT6420 chipset supports one IDE connector IDE3
and two serial connectors SATA3 & SATA4.
IDE3 is a 32-bit Enhanced PCI IDE and Ultra DMA 66/100/133 controller
that provides PIO mode 0~6, Bus Master, and Ultra DMA 66/100/133 function.
You can connect up to 2 hard disk drives---one IDE master and one IDE slave.
STAT3 & SATA4 are dual high-speed Serial ATA interface ports. Each
st
supports 1 generation serial ATA data rates of 150 MB/s. Both connectors are
fully compliant with Serial ATA 1.0 specifications. Each Serial ATA connector
can connect to 1 hard disk device. Please refer to Appendix C: VIA VT6420
Serial ATA Raid Introduction for detail software installation procedure.
2-20
SATA2 SATA1
1
7
IDE3
SATA4
SATA3
7 1