Serial Ata Raid Connectors Controlled By Nforce2 Raid Mcp: Sata1~Sata2; Sata1~Sata2 - MSI MS-6570E User Manual

Serial ATA RAID Connectors controlled by nForce2 RAID MCP:
SATA1/SATA2
The Southbridge of this mainboard is nForce2 RAID MCP which supports two
serial ATA connectors SATA1 and SATA2.
SATA1 and SATA2 are dual high-speed Serial ATA interface ports. Each sup-
ports 1 generation serial ATA data rates of 150 MB/s. Both connectors are fully
st
compliant with Serial ATA 1.0 specifications. Each Serial ATA connector can connect
to 1 hard disk device.
1
7
Serial ATA cable
Connect to serial ATA ports
MSI Reminds You...
Please do not fold the serial ATA cable in a 90-degree angle, which will
cause the loss of data during the transmission.
SATA1
7
SATA2
1
Hardware Setup
SATA1/SATA2 Pin Definition
PIN SIGNAL PIN
1 GND 2
3 TXN 4
5 RXN 6
7 GND
Take out the dust cover and
connect to the hard disk
devices
SIGNAL
TXP
GND
RXP
2-17