Making Voip Calls; Placing A Call; Answering A Waiting Call; Putting A Call On Hold - AudioCodes MP-202 User Manual

MP-202 Telephone Adapter
7

Making VoIP Calls

Users connected to the MP-202 can place calls, put calls on hold, transfer calls and
manage 3-way conferences. The following describes how to perform these operations.
7.1

Placing a Call

To place a call, take these steps:
1. Pick up the phone.
2. Make sure that you can hear a dial tone
3. Dial the remote party's number or pre-configured speed dial number.
7.2

Answering a Waiting Call

To answer a waiting call when 'Flash only' is configured (refer to
'
Configuring Dialing Parameters'
1. When you hear a call waiting tone (during a call), press 'Flash' on the phone; this puts
the active call on hold and switches to the waiting call.
2. To return to the original call, press Flash again. You can toggle from one party to
another as much as you like by pressing Flash.
To answer a waiting call when 'Flash + digits sequence'
configured (refer to '
1. When you hear the call waiting tone (during a call), press the 'Flash' key on the phone
and then the '1' key; this puts the original call on hold and switches to the waiting call.
2. To return to the original call, press Flash+1 again. You can toggle from one party to
another as much as you like by pressing Flash+1.
7.3

Putting a Call on Hold

To place the remote party on hold when 'Flash only' is configured
(refer to '
1. During a call, press 'Flash' on the phone; the phone plays a dial tone. At this point you
can initiate a second call by dialing another party's number.
User's Manual
Configuring Dialing Parameters'
Configuring Dialing Parameters'
on page 41):
on page 41):
57
7. Making VoIP Calls
on page 41):
February 2007
is