Changing The Factory Setting Of An Input Selector Button - Sony HT-SL70 Operating Instructions Manual

Changing the factory
setting of an input selector
button
If the factory settings of the input selector
buttons do not match your system components,
you can change them. For example, if you have
a CD player and you do not have a DVD
player, you can assign the DVD button to your
CD player.
1
Hold down the input selector button
whose input source you want to
change (for example, DVD).
2
Press the corresponding button of the
component you want to assign to the
input selector button (for example,
1 – CD player).
The following buttons are assigned to select
the input source:
To operate
CD player
VCR (command mode VTR 2*)
VCR (command mode VTR 3*)
DVD player
TV
DSS (Digital Satellite Receiver)
Tuner (this receiver)
DCS (Digital CS Tuner)
BSD (Digital BS Tuner)
Tuner (Component Tuner)
* Sony VCRs are operated with a VTR 2 or 3
setting. These correspond to 8mm and VHS
respectively.
Now you can use the DVD button to
control the CD player.
GB
36
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the input selector
buttons to their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
Press
1
2
3
4
5
6
7
8
9
0/10
HT-SL55 4-247-583-14(1) GB