Performing Initial Setup Operations - Sony HT-SL70 Operating Instructions Manual

After connecting all the components,
speakers, and AC power cord, output
a test tone to check that all the
speakers are connected correctly.
For details on outputting a test tone,
see page 18.
If no sound is heard from a speaker while
outputting a test tone or a test tone is output
from a speaker other than the one whose name
is currently displayed on the receiver, the
speaker may be short-circuited. If this happens,
check the speaker connection again.
To avoid damaging your
speakers
Make sure that you turn down the volume
before you turn off the receiver. When you turn
on the receiver, the volume remains at the level
you turn off the receiver.
Performing initial setup
operations
Once you have hooked up the speakers and
turned on the power, clear the receiver's
memory. Then specify the speaker parameters
(size, position, etc.) and perform any other
initial setup operations necessary for your
system.
Tip
To check the audio output during settings (to set up
while outputting the sound), check the connection
(see page 19).
Clearing the receiver's
memory
Before using your receiver for the first time, or
when you want to clear the receiver's memory,
do the following.
1
Press ?/1 to turn off the receiver.
2
Hold down ?/1 on the receiver for
5 seconds.
"INITIAL" appears in the display.
The following are reset to their factory
settings.
• All settings in the SET UP, LEVEL and
TONE menus.
• All sound field parameters.
• All preset stations.
• The sound fields memorized for each
INPUT SELECTOR and preset stations.
• The master volume is set to "VOL
MIN".
Performing initial setup
operations
Before using your receiver for the first time,
adjust MAIN MENU parameters so that the
receiver correspond to your system. For the
adjustable parameters, see the table on page 43.
See pages 14–18 for speaker settings and pages
30–31 for other settings.
HT-SL55 4-247-583-14(1) GB
GB
13