Sony HT-SL70 Operating Instructions Manual page 18

Multi channel surround setup
(continued)
Adjusting the speaker level
Use the remote while seated in your listening
position to adjust the level of each speaker.
Note
The receiver incorporates a new test tone with a
frequency centered at 800 Hz for easier speaker level
adjustment.
1
Press ?/1 to turn on the receiver.
2
Press TEST TONE.
"T. TONE" appears in the display and you
will hear the test tone from each speaker in
sequence.
Front (left) t Center t Front (right) t
Surround (right) t Surround (left) t
Sub woofer
3
Adjust the speaker level and balance
using the LEVEL menu so that the level
of the test tone sounds the same from
each speaker.
For details on the LEVEL menu, see page
24.
While adjusting, the test tone is output from
the speaker whose adjustment is performed.
4
Press TEST TONE again to turn off the
test tone.
Tip
You can adjust the level of all speakers at the same
time. Press MASTER VOL +/– on the remote or turn
MASTER VOLUME on the receiver.
Note
The adjusted value are shown in the display during
adjustment.
GB
18
Listening to the sub woofer
POWER LEVEL
MIN MAX
POWER POWER indicator
First, turn down the volume on the receiver.
The volume should be set to minimum before
you begin playing the program source.
1
Turn on the receiver and select the
program source.
2
Press POWER on the sub woofer.
The POWER indicator on the sub woofer
lights up in green.
3
Play the program source.
Adjusting the sound
Slight adjustments to the system can enhance
your sound enjoyment.
Adjusting the sub woofer
POWER
LEVEL
MIN MAX
LEVEL
1
Rotate LEVEL to adjust the volume.
Set the volume level to best suit your
preference according to the program source.
Note
Do not turn the volume of the woofer to maximum.
Extraneous noise may be heard.
HT-SL55 4-247-583-14(1) GB