Warning Message - Philips HP L1502 Service Manual

6
HP L1502
Go to cover page
Menu Level 1
Brightness
Contrast
Auto Adjustment
Advanced Menu
Exit
Warning message table
Item Attention Signals
1 Input Signal out of Range
2 No Input Signal
3 Going to Sleep
4 Adjusting... ..
5 OSD Lockout
6 Check Video Cable
Quit signal with cable 1. System blank and show WM
Disconnect cable
Out of range –1
Out of range –2
Out of range –3
Warning message table
BASIC OSD MODE CONFIGURATION
Mode Menu
Menu Level 2
ADJ Scale
ADJ Scale
Show "Adjusting... " message
Refer to table 8
Display Time
see power saver table
see power saver table
see power saver table
The Minus ( " - " ) button shall be a hot-key for the Auto-Adjustment process.
Menu button (
10secs Push menu key for 10 sec then display 10 sec WM "OSD Lockout"
see power saver table
Power Saver table
Power Saver - On
"Going to Sleep" 3 sec then sleep.
1. System blank and show
WM "Check Video Cable" 10
sec then moving about 50 sec.
2. Show WM "Going to
Sleep" 3 sec then sleep.
3. If push any key in sleep
mode, then repeat item 1 to 2.
1. System blank and show
moving WM "Input Signal
out of Range" 60 secs.
2. Show WM "Going to
Sleep" 3 sec then sleep.
3. If push any key in sleep
mode, then repeat item 1to 2.
1. Show moving WM
"Input Signal out of Range" 60 sec.
2. Menu key can active
during moving WM and
operate OSD menu.
3. WM disappear if menu
key push or after WM 60 sec.
1. Show moving WM
"Input Signal out of Range" 60 sec.
2. After moving WM 60 sec
then show WM "Going to Sleep"3 sec
then sleep.
3. If push any key in sleep
mode, then repeat item 1 to 2.
Menu Level 3
Condition
), shall be hot-key for OSD Menu Exit
Power Saver - Off
1. System blank and show
moving WM "No Input Signal" always.
1. System blank and show
WM "Check Video Cable" 10
sec then moving always.
1. System blank and show
moving WM "Input Signal
Out of Range" always.
1. Show moving WM
"Input Signal out of Range"60 sec.
2. Menu key can active
during moving WM and
operate OSD menu.
3. WM disappear if menu
key push or after WM 60 sec.
1. Show moving WM
"Input Signal out of Range"60 sec.
2. After moving WM 60 sec
then show WM "Going to
Sleep" 3 sec then sleep.
3. If push any key in sleep
mode, then repeat item 1 to 2.
Factory Reset
Y (FD = 100)
Y ( FD = 50)
Y (no FD)
Note
H<29.5 or
H>82.5 or
V<49 or
V>87 or
Vtotal>=1200
DownScaling
Ex.
1280x1024
85Hz