Warning Message - Philips 170B6CS/75 Service Manual

14
170B6 LCD
Go to cover page
Warning message table
Item Attention Signals
1 CANNOT DISPLAY THIS
VIDEO MODE, CHANGE
COMPUTER DISPLAY
INPUT TO 1280X1024 @
60HZ
2 NO VIDEO INPUT
3 CHECK CABLE
CONNECTION
4 ENTERING SLEEP MODE
5 WAITING FOR AUTOMATIC
ADJUSTMENT
6 USE 1280X 1024 FOR BEST
RESULT
7 OSD MAIN CONTROLS
LOCKED
8 OSD MAIN CONTROLS
UNLOCKED
9 the window of "VOLUME"
10 THIS IS 85HZ OVERSCAN,
CHANGE COMPUTER
DISPLAY INPUT TO
1280X1024@60HZ
11 the window of OSD
"MONITOR SETUP "
12 the window of
"BRIGHTNESS"
13 "SELECTED INPUT NOT
AVAILABLE"

Warning Message

Display Time Condition
30 mins This warning appears when the input signal from your computer is not in
a standard video mode or is out of the monitor s scanning range. After
30 mins, monitor enters sleeping mode.
30 mins This message appears when there is no signal input but with cable while
AC or DC power on. After 30 mins, monitor enters sleeping mode.
30 mins This message appears when a signal cable is disconnected while
monitor is working. After 30 mins, monitor enters sleeping mode.
3 secs This message appears when monitor is about to enter power saving
mode.
till auto adjustment This message is displayed when the auto adjustment button is pressed.
finished It disappears when automatic adjustments are completed.
On top of OSD main The message will show up at the top of the OSD main menu in red color
menu when the input resolution is not the 1280x1024.
3 secs / or Till "OSD This message will appear 3 seconds to indicate the OSD MAIN
MAIN CONTROLS CONTROLS status when to lock or un-lock it by pressing "MENU(OK) "
UNLOCKED" button for more than 10 seconds while there is video input from PC. This
appear function provides the alternative that user can lock all the OSD main
control in case user don t want the FOS performance setting to be
changed, for instance, during commercial exhibition.
3 secs This message will appear 3 seconds to indicate the OSD MAIN
CONTROLS status when to un-lock it by pressing "MENU (OK) " button
for more than 10 seconds while there is video input from PC.
60 secs This message will appear when the VOLUME button is pressed.
10 mins This message will appear 5 seconds in every 60 seconds for 10 minutes
when the input of PC video timing is at 85Hz mode.
Remark: AUTO is still functional in this mode
60 secs This message will appear when the "OK" button is pressed.
60 secs This message will appear when the BRIGHTNESS button is pressed.
3 secs This message will appear 3 seconds to indicate the SIGNAL SOURCE
status when change the signal source but it is not found while there is
video input from PC.