Warning Message - Philips 230WP7 Service Manual

8
230WP7 LCD
Go to cover page
Item Attention Signals
1 CANNOT DISPLAY THIS
VIDEO MODE, CHANGE
COMPUTER DISPLAY INPUT
TO 1920X1200 @ 60HZ
2 NO VIDEO INPUT
3 CHECK CABLE CONNECTION
4 ENTERING SLEEP MODE
5 WAITING FOR AUTOMATIC
ADJUSTMENT
6 USE 1920X 1200 FOR BEST
RESULT
7 OSD MAIN CONTROLS
LOCKED
8 OSD MAIN CONTROLS
UNLOCKED
9 The window of OSD
" "
MONITOR SETUP
"
10 The window of BRIGHTNESS
11 SELECTED INPUT NOT
AVAILABLE
Display Time Condition
30 mins This warning appears when the input signal from your computer is not in a standard
video mode or is out of the monitor s scanning range. After 30 mins, monitor enters
sleeping mode.
30 mins This message appears when there is no signal input but with cable while AC or DC
power on. After 30 mins, monitor enters sleeping mode.
30 mins This message appears when a signal cable is disconnected while monitor is
working. After 30 mins, monitor enters sleeping mode.
3 secs This message appears when monitor is about to enter power saving mode.
Till auto This message is displayed when the auto adjustment button is pressed. It
adjustment disappears when automatic adjustments are
finished completed.
On top of The message will show up at the top of the OSD main menu in red color when the
OSD main input resolution is not the 1920x1200.
menu
3 secs / or Till This message will appear 3 seconds to indicate the OSD MAIN CONTROLS status
"OSD MAIN when to lock or un-lock it by pressing MENU (OK) button for more than 10
CONTROLS seconds while there is video input from PC. This function provides the alternative
UNLOCKED" that user can lock all the OSD main control in case user do not want the FOS
appear performance setting to be changed, for instance,
during commercial exhibition.
3 secs This message will appear 3 seconds to indicate the OSD MAIN CONTROLS status
when to unlock it by pressing MENU(OK) button for more than 10 seconds while
there is video input from PC
60 secs This message will appear when the OK button is pressed.
"
60 secs This message will appear when the BRIGHTNESS button is pressed.
3 secs This message will appear 3 seconds to indicate the SIGNAL SOURCE status when
change the signal source but it is not found while there is video input from PC.
" "
" "
" "