Kidco Safeway G20 User Manual page 6

6
As an added safety measure, a stop pin has
been provided. Insert stop pin (s) from behind
locking latch bracket into hole oppo-site ope-
ning direction. Using 2 screws, screw into
upper set of screw holes.
Correct width will be reached by adjusting
gate sections and all four corner spindles.
Each spindle adjusts individually and may be
extended to varying lengths to allow for mol-
ding, uneven walls, etc. Spindles may be
extended a minimum of 1" but not more than
3" on each side.
Adjust gate sections, until gate is approximat-
ely right width and adjustment holes are alig-
ned on top and bottom. Sections should fit
without any distance between bars.
Gate sections must not be extended any
further than 4 adjustment holes from spind-
le ends of gate and holes must overlap at
two places on both top and bottom railing.
Place one set of expansion screws and screw
sockets (f & g) in top and bottom set of over-
lapping adjustment holes nearest hinge side
of gate and second set of expansion screws
and screw sockets in overlapping holes nea-
rest locking side of gate. Tighten with a
screwdriver.