Table 15. Supported Racks; Table 16. Rail Adjustability Ranges And Depth; Figure 11. 2U Threaded Rack Adapter Brackets Kit - Dell PowerEdge T610 Technical Manual

Dell
The adapter bracket kit includes 6 brackets to accommodate different rail lengths, plus 4 sets of
custom screws in common thread sizes. A detailed Getting Started Guide is included in the kit along
with directions for installing the brackets and mounting the rails into the brackets.
Depending on the depth of the rack used, it may be necessary to remove the server's bezel in order
to close the door of the rack. A minimum of 58 mm will be needed between the back surface of the
door panel and the front face of the EIA flange for the front door to close with the 11G server bezel
installed.
Below is a summary of the rack types supported by the T610 rails. Note that mounting in 2-post racks
is not supported.
Other factors to consider when deploying the T610 include the spacing between the front and rear
mounting flanges of the rack, the type and location of any equipment mounted in the back of the
rack such as power distribution units (PDUs), and the overall depth of the rack.
Rail
Product
ID
T610 C1
The adjustment range of the rails is a function of the type of rack in which they are being mounted.
The min-max values listed above represent the allowable distance between the front and back
mounting flanges in the rack. Rail depth represents the minimum depth of the rail as measured from
the rack front mounting flanges when the back rail bracket is positioned all the way forward.
PowerEdge T610 Technical Guide
Figure 11. 2U Threaded Rack Adapter Brackets Kit
Table 15.
Table 16. Rail Adjustability Ranges and Depth
Mounting Rail
Interface Type
ReadyRails Sliding
Supported Racks
Rail Adjustability Range (mm)
Square Round
Min Max Min Max
692 756 678 749
Rail Depth (mm)
Threaded
Without
CMA
Min Max
657 770 760
With
CMA
840
46