Rack Information; Overview; Rails; Figure 10. T610 Readyrails Sliding Rails With Optional Cma - Dell PowerEdge T610 Technical Manual

Hide thumbs Also See for PowerEdge T610:

Table of Contents

Dell

Rack Information

14.1

The ReadyRails™ sliding rail system for the PowerEdge T610 provides toolless support for racks with

square or unthreaded round mounting holes including all generations of Dell racks. They also support

tooled mounting in 4-post threaded racks using an optional adapter brackets kit. The optional cable

management arm (CMA) can be mounted on either the left or right side of the sliding rails without

the use of tools for fast and easy deployment.

The T610 is not compatible with any other Dell rails including previous generation rails, but it does

use the same rails as the T710. The T610 supports sliding rails only. Static rails are not supported.

Mounting in 2-post racks is not supported.

14.2

The ReadyRails sliding rails for the T610 support toolless mounting in 19"-wide, EIA-310-E compliant

square hole and unthreaded round hole racks and are available with or without the optional cable

management arm (CMA).

Figure 10.

The rails can be used in a threaded-hole rack only if threaded rack adapter brackets are installed.

The threaded rack adapter brackets are first mounted to the EIA flanges in the rack, and then the

rails are mounted into the brackets. The design of the brackets has been optimized to limit the

forward shift of the system in the rack to only 17.3 mm.

PowerEdge T610 Technical Guide

T610 ReadyRails Sliding Rails with Optional CMA

Table of Contents