Table of Contents
Advertisement
Dell
door panel and the front face of the EIA flange for the front door to close with the 11G server bezel
installed.
Below is a summary of the rack types supported by the T610 rails. Note that mounting in 2-post racks
is not supported.
Rail
Product
ID
T610
C1
*Requires the 2U Threaded Rack Adapter Brackets Kit (Dell part number PKCR1)
Other factors to consider when deploying the T610 include the spacing between the front and rear
mounting flanges of the rack, the type and location of any equipment mounted in the back of the
rack such as power distribution units (PDUs), and the overall depth of the rack.
Rail
Product
ID
T610
C1
The adjustment range of the rails is a function of the type of rack in which they are being mounted.
The min-max values listed above represent the allowable distance between the front and back
mounting flanges in the rack. Rail depth represents the minimum depth of the rail as measured from
the rack front mounting flanges when the back rail bracket is positioned all the way forward.
14.3 Cable Management Arm (CMA)
The optional cable management arm (CMA) for the T610 organizes and secures the cords and cables
exiting the back of the server and unfolds to allow the server to extend out of the rack without
having to detach the cables.
Some key features of the T610 CMA include:
Large U-shaped baskets to support dense cable loads
Open vent pattern for optimal airflow
PowerEdge T610 Technical Guide
Figure 11. 2U Threaded Rack Adapter Brackets Kit
Table 15.
Mounting Interface
ReadyRails
Table 16.
Rail Adjustability Ranges and Depth
Mounting
Rail
Interface
Type
ReadyRails
Sliding
Supported Racks
Rack Types Supported
Rail
Type
Square
√
Sliding
Rail Adjustability Range (mm)
Square
Round
Min
Max
Min
Max
692
756
678
749
4-Post
Round
Thread
Flush
√
√
*
X
Rail Depth (mm)
Threaded
Without
CMA
Min
Max
657
770
760
2-Post
Center
X
With
CMA
840
47
Advertisement
Table of Contents
