Weller WD 1 Operating Manual page 10

10-18
I II
I II
I II
7.1 Selecting Menu 1 special functions
Special functions
STANDBY
SETBACK
AUTO OFF
OFFSET
WINDOW
°C / °F
1. Press and hold down the UP and DOWN buttons simultaneously.
"– 1 –" appears in the display after 2 s.
2. Release the buttons.
Selection of the special functions of Menu 1 is activated.
III
The settings can now be made.
- Press the I, II buttons to select menu items.
- Press the III button to exit the menu again (EXIT).
Resetting the special functions to the factory settings
1. Press and hold down button III.
2. Then press the UP and DOWN buttons simultaneously.
"FSE" appears in the display.
The soldering station is now reset to the factory settings.
III
Setting the standby temperature
The standby temperature is automatically set after a temperature
deactivation. The actual temperature flashes in the display.
"STANDBY" appears on the display
(100 °C – 300 °C / 200 °F – 600 °F).
1. Select the menu item STANDBY in Menu 1.
2. Set the setpoint value for the standby temperature with the UP or
DOWN button.
III
3. Press the I (back) or II (forwards) button to switch to the next
menu item.
WD 1 (M) / WD 1000 (M)
Navigation
I
II
EXIT III