VRinsight
Multi Switch Panel
Falcon 4.0 Allied Force
Step 1
Step 2
Step 3
Copyright © 2010 VRinsight | SimWare Simulations
- If not yet done, connect the Multi Switc
cable to a USB 2.0 receptacle.
- Run Falcon and go to SETUP-KEYS.
Note: Falcon4AF_patch_1.0.13 should be installed
- Assign function for A1 ~ B6, T1 ~ T4, E1 ~ E4.
- Click the Apply button and save the file.
Click the Apply button and save the file.
- Go to CONTROLLERS and chose from the FLIGHT
Go to CONTROLLERS and chose from the FLIGHT
CONTROLLERS dropdown list usb pad.
- Rotate R1 and R2. Knob R1 will be assigned as
Rotate R1 and R2. Knob R1 will be assigned as
aileron and knob R2 as elevator.
- Move up switch T1 and switch T3 up and down.
Move up switch T1 and switch T3 up and down.
T1 is then assigned as Throttle and T3 as rudder.
T1 is then assigned as Throttle and T3 as rudder.
- When you are finished, click the OK button to save
When you are finished, click the OK button to save
the changes.
SimWare Simulations
Falcon4AF_patch_1.0.13 should be installed
before use.
function for A1 ~ B6, T1 ~ T4, E1 ~ E4.
Version: 1.00 | November 8, 2010
Version: 1.00 | November 8, 2010
Assignment Procedures
Assignment Procedures
ch Panel USB
Need help?
Do you have a question about the MS Panel and is the answer not in the manual?