Darning - Janome 6260QC Instruction Manual

Janome 6260QC Instruction Manual
1
23
2
1
(A)
www.aaasewing.com
38
3
3
2
5
7
6
(B)

Darning

Machine setting
Pattern
1
Foot
2
Thread tension
3
1. Pull the button holder all the way out.
2. Draw the needle thread to the left through the hole on
the foot.
3. Lower the needle into the fabric where start to sew.
Lower the foot and depress the foot control.
4. The machine will darn and stop automatically. The
LED display will show a blinking dot when the darning
is finished.
4
NOTE: The maximum length and width of the darning
are 2.5 cm and 0.7cm respectively.
Sew another layer of darning over the previous
one, at the right angle.
Button holder
1
Starting point
2
Maximum length (2.5 cm)
3
Maximum width (0.7 cm)
4
Blinking dot
5
To sew a shorter darning
Sew the first row to the required length and press the
reverse stitch button. Continue to sew the remaining
stitches until the machine stops automatically.
6 Reverse stitch button
Required length
7
Adjusting the evenness of the darning
If the darning is not even, correct it by pressing the stitch
length adjusting keys.
The LED display shows d5, which indicates the neutral
setting.
(A) If the left corner is lower than the right side, press the
minus (Ð) key to correct it.
(B) If the right corner is lower than the left side, press
the plus (+) key to correct it.
NOTE: Allowable adjustment range is d1-d9.
Janomesewing machine
#23
R: Automatic buttonhole foot
Auto
6260QC Owners Manual/ User Guide