Square Buttonhole - Janome 6260QC Instruction Manual

Janome 6260QC Instruction Manual
1
16
Sensor
2
1
1
2
4
A
3
3
5
www.aaasewing.com
26
3
2
B

Square buttonhole

Machine setting
1 Pattern
Foot
2
3 Thread tension
NOTES: The size of buttonhole is automatically set by
placing the button in the rear of the automatic
buttonhole foot R.
The button holder of the foot takes a button
size up to 2.5 cm (1ý) in diameter.
Make a test buttonhole on a scrap fabrics of
the actual garment.
Use the interfacing on the stretch fabrics.
Raise the needle by turning the handwheel. Raise the
1
foot and place the automatic buttonhole foot with its
pin just under the groove of the foot holder. Lower the
presser bar to attach the foot.
1 Groove
Pin
2
2 Pull the button holder to the back (A), and place the
button in it. Push back the button holder toward you
(B) to hold the button.
3 Button holder
NOTE: If the button is extremely thick, make a test
buttonhole. If it is difficult to fit the button through
the test buttonhole, lengthen the buttonhole by
pulling the button holder back to create a gap.
Gap
4
3 Pull the buttonhole lever downward as far as it will go.
5 Buttonhole lever
6260QC Owners Manual/ User Guide
Janomesewing machine
#16
R: Automatic buttonhole foot
Auto