Section 2: Set Up; Items Needed For Setup - Carba-Tec CTH-110L 1PH Owner's Manual

Section 2: Set Up

Items Needed for Setup

The following items may assist you in completing the
assembly and set up process. Some of these items
may be included with your machine.
Description
• Safety Glasses
• Degreaser
• Rags
• Phillips head Screwdrivers (various sizes)
• Flat head Screwdrivers (various sizes)
• Socket Set (Imp & Metric)
• Shifting Spanners
• Hammers (Standard and Rubber)
• Open End and Ring Spanners (Imp & Metric)
• Wax or Surface Protectant
Unpacking and Inventory
This machine is very heavy. A minimum of two people
WARNING
are required to unpack and move it into place.
Do not attempmt to assemble this machine without
having help near by. Some of the components may be
heavy and may require more then one person to
attach in a safe manner.
Check shipping carton and machine for damage
before unpackaging. A damaged carton may not
mean a damaged machine. Carefully remove
packaging materials, parts and machine from shipping
carton. Always check for and remove protective
shipping materials around motors and moving parts.
Lay out all parts on a clean work surface in the groups
they were packaged in.
Remove any protective materials and coatings from all
of the parts and the table saw. The protective coatings
can be removed by spraying WD-40, degreaser or
similar product on them and wiping it off with a soft
cloth. This may need redone several times before all of
the protective coatings are removed completely.
After cleaning, apply a good quality non-silicon paste
wax (or specific surface protectant) to any unpainted
surfaces. Make sure to buff out the wax before
assembly.
Verify that all items are accounted for before
discarding the shipping box.
7
WARNING
If any parts are missing, do not attempt to plug in the
power cord and turn "ON" the machine. The machine
should only be turned "ON" after any missing parts
have been obtained and installed correctly. For
assistance with missing parts, contact your purchase
point or Carba-Tec.
MAKE CERTAIN THAT THE SAW IS DISCON-
NECTED FROM THE POWER SOURCE.
Installation and Leveling
Final location for the saw must be level, dry, well
lighted, and have enough room to allow movement
around the saw with long pieces of wood stock.
Level the saw front to back and side to side, using a
carpenter's level placed on the table. Use shims under
the corners, if necessary, but make sure the saw is
stable prior to putting the machine into service.
www.carbatec.com.au