Installing Blade - Carba-Tec CTH-110L 1PH Owner's Manual

Assembly Instructions

Installing Blade

WARNING
MAKE CERTAIN THAT THE SAW IS
DISCONNECTED FROM THE POWER SOURCE.
This machine is fitted with a 5/8" arbor. Please ensure
any blade fitted has this sized arbor diameter, or has a
correctly sized bush fitted to the blade to ensure a
correct fit.
1. Use the Handwheels to raise the blade arbor fully,
set the bevel angle at zero, and lock the saw by
tightening the lock knob in the middle of the handwheel.
2. Remove Table infill plate (if fitted) and the arbor nut
and flange.
3. Place the blade on the arbor shaft, making sure the
teeth point down, towards the front of the saw (see
diagram below)
Rear of machine
4. Replace the flange (A) and the arbor nut (B). Ensure
the nut is fitted with the step towards the blade, and that
it locates inside the flange. See Fig 11 &12.
5. Using the wrenches provided, securely tighten the
arbor nut and remove the wrench. See Fig. 13
11
Front of machine
A
Fig.11
B
Fig.12
Fig.13
www.carbatec.com.au