Section 3: Operations; Pre-Run Check; Test Run - Carba-Tec CTH-110L 1PH Owner's Manual

Section 3: Operations

Pre-Run Check

Before you begin to use your Table Saw, you should
give it a thorough inspection, making sure you ask
yourself the following questions.
1. Is the blade mounted correctly?
2. Is the saw stable?
Rear of machine Front of machine
3. Is it wired properly?
4. Is your electrical system properly configured?
5. Have you checked your workpiece for obvious
defects?
6. Is the guard assembly installed and funtional?
7. Have you checked the saw blade clearance when it
is adjusted to varying angles and depths?
8. Have you read all the warnings and directions
regarding the operation of this machine?
9. Have you fitted adequate dust extraction?
10.Have you ensured the work area, and the saw table
top, saw blade and entire work area are free from any
loose items, offcuts or obstructions?

Test Run

1.. Face the table saw and stand to the left of the
blade path.
2. With one finger on the START button and one
finger on the STOP button, turn the saw on. Be ready
to turn the saw off in case of a mishap.
3. Watch and listen to the saw. Note whether there
are any unusual sounds or excessive vibrations.
4. If anything appears abnormal, immediately turn off
the saw, unplug it, identify and fix the problems. If a
problem exists that is beyond the scope of this
manual, contact your dealer.
5. If the saw is behaving normally, turn it off and
prepare to make a cut according to the instructions
outlined in the following section.
www.carbatec.com.au
17