Section 4: Maintenance; Changing Belts - Carba-Tec CTH-110L 1PH Owner's Manual

10" 3hp left tilting table saw
Table of Contents

Advertisement

Section 4: Maintenance

This table saw requires very little maintenance other
than minor lubrication and cleaning. The following
sections detail what will need to be done in order to
WARNING
assure continued operation of your saw.
MAKE CERTAIN THAT THE SAW IS
DISCONNECTED FROM THE POWER SOURCE.
Cleaning
Keep the inside of the cabinet clear of saw dust and
wood chips. With the table saw unplugged, vacuum
out the inside of the cabinet or blow out the inside with
an air hose. Be sure to use air pressure no higher than
WARNING
50 P.S.I as high pressure air may damage insulation.
Be sure to wear protective eyewear and dust mask
when cleaning out the cabinet of the saw.
Lubrication
The table saw has sealed lubricated bearings in the
motor housing and the arbor assembly that do not
require any additional lubrication from the operator.
The tabletop is an unfinished metal surface that, over
time, will accumulate rust if not properly cared for.
When the table saw is not in use, keep a light coat of
WD-40 on the table top as this will help prevent rust
from occurring. If rust has already accumulated on the
table, use WD-40 and a fine steel wool to get rid of the
rust. Using a quality paste wax on the tabletop and
wings is a good preventative measure to help prevent
rust from forming. There are specific products
designed to keep you machinery protected and in
good condition. Please talk to Carba-Tec if you
require any information on these spaciality products.
23
WARNING
MAKE CERTAIN THAT THE SAW IS
DISCONNECTED FROM THE POWER SOURCE.

Changing Belts

1. Lower the blade to its lowest point.
2. Loosen the bolt/s that locks the motor pivot bracket
(NOT the pivoting bolt)
3. Take the tension off of the belts by lifting up on the
motor.
4. Remove the belts from the arbor and motor pulleys.
5. Replace and tension the belts. The weight of the
motor should apply enough tension to the belts.
6. Tighten bolt/s.
7. Check the belt tension after the saw has been used
for a few hours and adjust as necessary.
www.carbatec.com.au

Advertisement

Table of Contents
loading

Related Products for Carba-Tec CTH-110L 1PH

Table of Contents