Table Insert Adjustment; Blade Alignment - Carba-Tec CTH-110L 1PH Owner's Manual

Assembly Instructions
Adjustments
A
Aligning Blade Guard and Riving
Knife Assembly
1. Raise blade guard away from the table and hold the
anti-kickback fingers (A) out of the way.
B
2. Using an accurate straight edge, check to see that the
straight edge rests against the Riving Knife (A) and
against the face of the saw blade (B). See Fig. 14.
Fig.14
3. If an adjustment is necessary, refer back to the
section titled BLADE GUARD ASSEMBLY in the
ASSEMBLY section of this manual.
A

Table Insert Adjustment

A
1. Lower blade completely.
2. Unscrew infill plate joiner, and place the open end of
the insert under the splitter and lower the insert into the
opening. Reconnect infill plate joiner.
A
A
3. Adjust the table insert flush with the table by turning
four leveling grub screws (A) and using a straight edge.
B
4. Attach infill plate to table with the machine screw
Fig.15
provided (B). See Fig 15.

Blade Alignment

A
See Fig 16 & 17 - Blade alignment with the table is
adjusted at the factory. After a period of use, or after
moving the saw to another location, the blade may no
C
longer be aligned with the table. To check and align the
blade:
1. Raise the blade guard up and out of the way of the
B
blade (A).
Fig.16
2. Unlock fence and move away from the blade so as to
expose the right mitre slot (B).
3. Choose a tooth on the far side of the blade and
directly over the insert. Mark the tooth with a marker.
Measure the distance from the side of the blade to the
right mitre slot edge using a combination square (C). Make
sure to measure between the teeth, not on the tooth.
4. Rotate the blade toward the front so that the marked
tooth is just above the insert. Measure the distance from
the side of the blade to the right mitre slot edge. The two
Fig.17
measurements should be the same.
www.carbatec.com.au
12