Brother MFC-7470D Basic User's Manual page 87

Error Message
Fuser Error
Init Unable XX
(XX = Error Code)
Jam Duplex
Jam Inside
Jam Rear
Jam Tray
Limit Exceeded
Manual Feed
Cause
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
The fuser unit is too hot.
The machine has a mechanical
problem.
The paper is jammed in the
duplex tray at the back of the
machine.
The paper is jammed inside the
machine.
The paper is jammed in the back
of the machine.
The paper is jammed in the paper
tray of the machine.
The Page Limit set in Secure
Function Lock 2.0 for your ID was
reached.
Manual Feed was selected as
the paper source when there was
no paper in the manual feed slot.
Action
(For )
MFC-7360
Received fax messages still in memory will
be lost when the machine is turned off. See
Transferring your faxes or Fax Journal
report on page 83 before disconnecting the
machine so you will not lose any important
messages. Then, turn the power switch off,
wait a few seconds, and then turn it on
again. Leave the machine for 15 minutes
with the power on.
(For MFC-7470D / MFC-7860DN)
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave
the machine for 15 minutes with the power
on.
(For )
 MFC-7360 Received fax
messages still in memory will be lost
when the machine is turned off. See
Transferring your faxes or Fax Journal
report on page 83 before disconnecting
the machine so you will not lose any
important messages.
Then, disconnect the machine from the
power for several minutes and then
reconnect it.
(For MFC-7470D / MFC-7860DN)
Disconnect the machine from the power
for several minutes, then reconnect it.
If the problem continues, call your

Brother dealer.
(See Paper is jammed in the Duplex Tray
(MFC-7470D / MFC-7860DN) on page 94.)
(See Paper is jammed inside the machine
on page 89.)
(See Paper is jammed at the back of the
machine on page 87.)
(See Paper is jammed in the standard paper
tray on page 86.)
Contact your administrator to check your
Secure Function Lock Settings.
Place a sheet of paper in the manual feed
slot. (See Loading paper in the manual feed
slot on page 12.)
Troubleshooting
B
79